To make a paper plate snowman you will need: two paper plates (big size), a bottle of glue, marker, hole punch, scissors, piece of yarn, orange pipe cleaner, red construction paper and black construction paper.
To start you need to cut the wrinkly part off of one of the paper plates, just around the rim. Now you will have a large plate and a smaller plate. Next use the hole punch to punch a hole in the big paper plate close to the edge, do the same with the small paper plate. Now just tie the two together and just tie it into a bow. The next thing to make is the hat and boots out of the black construction paper. To do this, fold the piece of paper in half and make an outline of the hat. Make sure you leave room for the boots so that you can use the same piece of paper for both. Cut them out and unfold your hat. Next, fold the red construction paper in half to make your mittens. Now put a little bit of glue on the bottom of the hat and stick it to the top of the smaller plate. You will do the same for the boots, gluing them to the bottom of the larger plate. Then glue the mittens on the sides. To make the nose cut a small piece of orange pipe cleaner, you can either glue it on or poke it through the plate. You can use the wiggly eyes or you can just use a marker or crayon. You can also use marker or crayon to make the mouth as well. To make the buttons, you can out pieces of construction paper. |